ATMEGA16A-AU

The ATmega16A is a low-power CMOS 8-bit microcontroller based on the Atmel AVR enhanced RISC
architecture. By executing powerful instructions in a single clock cycle, the ATmega16A achieves throughputs
approaching 1MIPS per MHz allowing the system designer to optimize power consumption versus processing
speed.


Download Details PDF

Notice:

In stock will ship in 2 days. Real-time inventory pls confirm with us.

INQUIRY ONLINE




    SPECIFICATION

    High-performance, Low-power Atmel AVR 8-bit Microcontroller
    Advanced RISC Architecture
    ̶ 131 Powerful Instructions – Most Single-clock Cycle Execution
    ̶ 32 x 8 General Purpose Working Registers
    ̶ Fully Static Operation
    ̶ Up to 16MIPS Throughput at 16MHz
    ̶ On-chip 2-cycle Multiplier
    High Endurance Non-volatile Memory segments
    ̶ 16KBytes of In-System Self-programmable Flash program memory
    ̶ 512Bytes EEPROM
    ̶ 1KByte Internal SRAM
    ̶ Write/Erase Cycles: 10,000 Flash/100,000 EEPROM
    ̶ Data retention: 20 years at 85°C/100 years at 25°C(1)
    ̶ Optional Boot Code Section with Independent Lock Bits
    In-System Programming by On-chip Boot Program
    True Read-While-Write Operation
    ̶ Programming Lock for Software Security
    JTAG (IEEE std. 1149.1 Compliant) Interface
    ̶ Boundary-scan Capabilities According to the JTAG Standard
    ̶ Extensive On-chip Debug Support
    ̶ Programming of Flash, EEPROM, Fuses, and Lock Bits through the JTAG
    Interface
    Peripheral Features
    ̶ Two 8-bit Timer/Counters with Separate Prescalers and Compare Modes
    ̶ One 16-bit Timer/Counter with Separate Prescaler, Compare Mode, and
    Capture Mode
    ̶ Real Time Counter with Separate Oscillator
    ̶ Four PWM Channels
    ̶ 8-channel, 10-bit ADC
    8 Single-ended Channels
    7 Differential Channels in TQFP Package Only
    2 Differential Channels with Programmable Gain at 1x, 10x, or 200x
    ̶ Byte-oriented Two-wire Serial Interface
    ̶ Programmable Serial USART
    ̶ Master/Slave SPI Serial Interface
    ̶ Programmable Watchdog Timer with Separate On-chip Oscillator
    ̶ On-chip Analog Comparator

    Special Microcontroller Features
    ̶ Power-on Reset and Programmable Brown-out Detection
    ̶ Internal Calibrated RC Oscillator
    ̶ External and Internal Interrupt Sources
    ̶ Six Sleep Modes: Idle, ADC Noise Reduction, Power-save, Power-down, Standby and Extended Standby
    I/O and Packages
    ̶ 32 Programmable I/O Lines
    ̶ 40-pin PDIP, 44-lead TQFP, and 44-pad QFN/MLF
    Operating Voltages
    ̶ 2.7 – 5.5V
    Speed Grades
    ̶ 0 – 16MHz
    Power Consumption @ 1MHz, 3V, and 25°C
    ̶ Active: 0.6mA
    ̶ Idle Mode: 0.2mA
    ̶ Power-down Mode: < 1µA